DTS XD10 Especificaciones descargar pdf (Pagina 30)

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0

1.8.3. Video Setup

Set Image

Set Player Zone

Set AutoStop

Set Application

Set Test/Normal

Factory Settings

VIDEO SETUP

OPTIONAL PASSWORD PROTECTION

SYSTEM SETUP

MAIN MENU

The Video Setup controls are present only if your unit is equipped

with the Video Option. If this option is not installed, the controls

in this menu section will be inactive. With the Video Option

installed, this menu provides controls for optimal setup,

calibration, and control of an installed digital video projection

system.

1.8.3.1. Set Image

Select submenus for specifying the appropriate image resolution,

for adjusting image brightness and contrast, or for adjusting image

position on the screen. Once the optimal settings have been made,

these controls will not need further adjustment unless the unit is

connected to a different video projector.

Selecting any of the submenus will display an adjustment screen where you can alter the current setting

using the ▲ and ▼buttons. Press ENTER to confirm your setting and return to the Set Image menu.

• Select 1024 x 768, or 1280 x 1024 Resolution, to match that of the video projector in use.

• Play a video sample and adjust Brightness and Contrast for optimal viewing in your theater.

• Play a 16:9 video image and use the Calibration controls to center (Location) and squeeze

(Width) the image as necessary to best fit your screen.

Set Image Menu

x Resolution

x Brightness

x Contrast

x Cal Location

x Cal Width

Use ▲ and ▼ to move the cursor,

then use ► to open submenu.

Choose Resolution and this screen will display.

Resolution Menu

( )1024 x 768

( )1280 x 1024

Use ▲ and ▼ to move the cursor,

then press ENTER to activate.

Note: Image calibration (Cal Location, next page) must be done separately for each

resolution (1024x768 or 1280x1024).

Choose Brightness and this screen will display.

Set Brightness

Brightness: 55/100

Use ▲ and ▼ to change the

Brightness factor, then press

ENTER to Save your setting.

Choose Contrast and this screen will display.

Set Contrast

Contrast: 55/100

Use ▲ and ▼ to change the Contrast

factor, then press ENTER to Save

your setting.

Operational Overview Document #: 9301E692001.0

1-18

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 151 152

Comentarios a estos manuales

Sin comentarios

DTS XD10 Especificaciones Pagina 30

Comentarios a estos manuales