DTS XD10 Especificaciones Pagina 145

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 144
TITLE
Reader Head LED Voltage Calibration
NUMBER
TN-E550
REV
A
Page 1
of 3
DATE PREPARED
August 6, 2002
CREATED BY:
K. Hultgren
EFFECTIVE DATE
8/7/02
APPROVED BY:
B. Plunkett
DTS, 5171 Clareton Dr., Agoura Hills, CA 91301 Contact Document Control for the latest revision.
All reader heads must be periodically checked for proper gain. It is easily done using a multimeter and
with NO
film loaded through the reader. For demonstration purposes, the reader is shown removed from
the projector.
TOOLS REQUIRED
DTS player 1/16” (1.58 mm) Allen-head (hex) screwdriver Multimeter
Timecode cable Small flat-bladed screwdriver
Remove the reader’s back cover by removing the –4- hex screws. Save the screws.
First, set the meter to DC volts. Connect leads to TP1 (“+” signal) and TP2 (ground) on the D424 board.
Then, connect the reader to a powered DTS player. The reader gets its power from the DTS player.
Vista de pagina 144

Comentarios a estos manuales

Sin comentarios